Motion Setup - Planet DVR-450 User Manual

If external alarm sensor(s) be triggered, beep sound from buzzer would be occurred during two seconds
while choosing ENABLE.

MOTION SETUP

DVR has built-in video motion detection function. Motion detection area can be selected separately for
each camera. When your DVR detects motions, it begins to record multiplexed video signals from the
camera which motion is detected and display that camera image with up to 30 seconds while selecting
POP-UP DISPLAY
To access MOTION SETUP, using DOWN or UP button to select the item in MAIN MENU, then press
ENTER into setup menu when MOTION SETUP is highlighted with blue color. The menu below will
appear on monitor.
1) SENSITIVITY:
DVR supports 5 sensitivity levels. Higher sensitivity will detection motions easily even there is a brightness
change. It can be selected using LEFT or RIGHT button.
2) FRAME RATE:
The recording frame rate after motion is detected. It can be selected using LEFT or RIGHT button.
3) DURATION:
It defines recording duration after motion is detected. This DVR support 10 ,30sec,
1,2,3,4,5,6,7,8,9,10,20,30,40,50,60 minutes. It can be selected using LEFT or RIGHT
è On. (Refer to the section DISPLAY SETUPà
MOTION SETUP
1 SENSITIVITY
2 FRAME RATE
3 DURATION
4 CAM1
5 CAM2
6 CAM3
7 CAM4
8 BUZZER ALERT
ENTER
5 steps (very low, low, normal, high, very high)
60, 30, 15, 10, 5, 1, 0.5 IPS.(NTSC)
50, 25, 12, 10, 5, 1, 0.5 IPS. (PAL)
: normal
: 60/ IPS
: 1 MIN
:
DISABLE
:
DISABLE
:
DISABLE
:
DISABLE
:
DISABLE
▲ ▼ ◀ ▶
EXIT
)
POP-UP DISPLAY
19