Table of Contents
Advertisement
button.
4) CAM1, CAM2, CAM3, CAM4:
DISABLE means that function of motion detection is unavailable.
ALL means that entire image area is selected for motion detection.
SETUP can determine image area where want to be monitored. Total motion area consists of 14x10
blocks. To select arbitrary motion zone, select SETUP using LEFT or RIGHT button. And then press
ENTER button to designate motion areas in 14x10 blocks. You can use LEFT or RIGHT button for
horizontal movement UP or DOWN button for vertical movement, ENTER button for selection. User can
define the area of the image where you don't want to detect motion and vice versa.
Selected blocks in 14x10 blocks will be blinking and those areas are NOT used for motion detection
areas.
To remove previous defined image blocks for motion detection, press ENTER button again at the specific
blinking block. Finish defining motion detection zone, press MENU/ESC button to return to upper Menu.
Motion detection zone is the area which edge of the motion blocks is not flickering.
5) BUZZER ALERT:
If motions are detected in decided motion detection area, beep sound from buzzer by would be occurred
during two seconds by selecting ENABLE.
DISABLE/ ALL/ SETUP
< The example of motion area setup >
DISABLE/ ENABLE
20
Advertisement
Table of Contents
