Using The Timer; Setting The Clock; Setting The Wake-Up Timer - Pioneer X-SMC3-K Operating Instructions Manual

Changing the settings
Settings
BT PIN Select
(0000/1234/8888)
Volume Limit Setting
(On/Off)
Internet Parental Lock
(Change Password/Internet
Parental Lock)
Auto mode select
(Power Save mode/Demo
Mode/Off)
Language
(English/Other languages)
Quick Start Mode
(On/Off)
Software Update
System Info

Using the timer

Setting the clock

Setting the clock before using the timer.
1 Press SET UP.
The Initial Setup screen is displayed on the main display.
2 Select Clock Setting
3 Select Auto or Manual.
If you select Manual, go to step 4.
• Auto works only when this unit is connected to the
network. Connect to the network if you want to use
automatic time adjustment.
Note
1 You'll need to set the clock again if you unplug the unit (or in case of a power failure).
2 The "AM" and "PM" indicators appear only when the Time Format is set to the 12H mode.
3 When the unit is in iPod, FM, Internet Radio, or Aux modes, you can set the timer.
What it does
Bluetooth
Use this to set the
When On is selected, the volume can be set between 0 to 30.
Each time this setting has been changed, the volume becomes to 0.
Restricts usage of internet radio using password. Select Internet Parental Lock to On/Off.
You can set up the password from Change Password. (page 33)
When Power Save mode is selected, the unit will be automatically in the standby mode if no
operation has done for more than 30 minutes.
When Demo Mode is selected, the demonstration screen will start if no operation has done for more
than 5 minutes.
Change the language of the operation messages displayed on the main display.
Other languages: French, German, Netherlands, Italian, Spanish, Russian, Japanese
When this is set to On, the time required for bootup will be shortened. In addition, power-on will
occur simultaneously when AirPlay is performed. Note, however, that when Quick Start Mode is set
to On, the electrical current consumed in the power-off (standby) mode will be about the same as
that required when the power is turned on. Also, if the power cord is disconnected while Quick Start
Mode is set to On, the next time the plug is reconnected, about one minute warm-up will be required
before the unit responds. Wait for one minute after reconnecting the cord before pressing
STANDBY/ON.
Use this to update unit software.
Use this to check unit information details.
1

Clock Adjustment.
PIN code. (page 19)
Use /// or number buttons to adjust
4
the clock, then press ENTER.
• Using / moves the adjusting digit (hour/minute/
2
second/AM, PM ).
• Using / increases or decreases values.
Clock Adjustment
2 21
H:M:S AM/PM
• If you press RETURN, the previous screen will be
displayed.

Setting the wake-up timer

1 Press SET UP.
The Initial Setup screen is displayed on the main display.
2 Select Timer Setting.
The Timer Setting screen is displayed.
0 AM
3
12
29
En