Table of Contents
Advertisement
Operating this unit
2
Press MULTI-CONTROL to display the
setting mode.
# Press DISP/BACK/SCRL to return to the pre-
vious display.
3
Turn MULTI-CONTROL to select an ap-
propriate DVD output signal.
NTSC—PAL
# You can also perform the same operations by
pressing a or b.
4
Press MULTI-CONTROL to determine
the selection.
# Even if the menu has been canceled before
determination, operation is settled.
Setting the display connection
on or off
You can use this unit with or without the dis-
play. When using this unit connected to the
display, you can turn the display connection
setting on or off. If you turn this function on,
the detailed text information of the DVD and
USB appears on the display.
1
Use MULTI-CONTROL to select V.OUT in
the initial setting menu.
Refer to Adjusting initial settings on page 35.
2
Press MULTI-CONTROL to turn display
connection on.
# To turn display connection off, press
MULTI-CONTROL again.
Note
The operation of this unit differs according to the
display connection on/off setting. The examples
are as follows:
! Playing a compressed audio file and display-
ing the file name list mode
— When the display connection is set to on,
the files of the currently playing folder are
displayed.
— When the display connection is set to off,
the file of the root folder is displayed.
! Playing a compressed audio file and pressing
DISP/BACK/SCRL in the file name list
— When the display connection is set to on,
the name of the currently playing file is se-
lected.
— When the display connection is set to off,
you can return to the previous list (the
folder one level higher).
CRB2941-A/N
<
Section
02
37
En
>37
Advertisement
Table of Contents
