Table of Contents
Advertisement
Section
Operating this unit
02
# You can also perform the same operations by
pressing a or b.
4
Press MULTI-CONTROL to determine
the selection.
# Even if the menu has been canceled before
determination, operation is settled.
Setting the AM tuning step
The AM tuning step can be switched between
9 kHz, the preset step, and 10 kHz. When
using the tuner in North, Central or South
America, reset the tuning step from 9 kHz (531
kHz to 1 602 kHz allowable) to 10 kHz (530 kHz
to 1 640 kHz allowable).
1
Use MULTI-CONTROL to select AM STEP
in the initial setting menu.
Refer to Adjusting initial settings on the pre-
vious page.
2
Press MULTI-CONTROL to display the
setting mode.
3
Turn MULTI-CONTROL to select the AM
tuning step.
Turning MULTI-CONTROL will switch the AM
tuning step between 9 kHz and 10 kHz. The se-
lected AM tuning step will appear in the dis-
play.
# You can also perform the same operations by
pressing a or b.
4
Press MULTI-CONTROL to determine
the selection.
# Even if the menu has been canceled before
determination, operation is settled.
Switching the auxiliary setting
It is possible to use auxiliary device with this
unit. Activate the auxiliary setting when using
auxiliary device connected to this unit.
36
En
1
Use MULTI-CONTROL to select AUX1/
AUX2/AUX in the initial setting menu.
Refer to Adjusting initial settings on the pre-
vious page.
2
Press MULTI-CONTROL to turn AUX1/
AUX2/AUX on.
# To turn AUX1/AUX2/AUX off, press
MULTI-CONTROL again.
Switching the ever scroll
When Ever Scroll is set to ON, recorded text in-
formation scrolls continuously in the display.
Set to OFF if you prefer the information to
scroll just once.
1
Use MULTI-CONTROL to select SCROLL
in the initial setting menu.
Refer to Adjusting initial settings on the pre-
vious page.
2
Press MULTI-CONTROL to display the
setting mode.
# Press DISP/BACK/SCRL to return to the pre-
vious display.
3
Turn MULTI-CONTROL to select the de-
sired setting.
EVER (ever)—OFF (off)
# You can also perform the same operations by
pressing a or b.
4
Press MULTI-CONTROL to determine
the selection.
# Even if the menu has been canceled before
determination, operation is settled.
Setting the DVD output signal
When this unit is connected to a display, you
need to adjust the DVD output signal suitable
to DVD and your display signal setting.
1
Use MULTI-CONTROL to select
COLOR SYS in the initial setting menu.
Refer to Adjusting initial settings on the pre-
vious page.
CRB2941-A/N
<
>36
Advertisement
Table of Contents
