Connecting To A Bluetooth Device Automatically; Switching Visible Unit; Displaying Bd (Bluetooth Device) Address - Pioneer AVH-P5250BT Operation Manual

Section
12 Detailed instructions
If you cannot open the connection between
your Bluetooth device and this unit from your
Bluetooth device, you can use this function to
establish a connection.
1 Display the Bluetooth Connection
Menu.
Refer to Introduction of Bluetooth telephone op-
erations on page 24.
2 Touch Special Device to select the spe-
cial device.
# Bluetooth devices that are difficult to establish
a connection with are called special devices. If
your Bluetooth device is listed as a special device,
select the appropriate one.
3 Touch the special device list to open the
connection.
This unit is now on standby for a connection
with the Bluetooth device.
# If five devices are already paired,
Memory Full is displayed and pairing cannot be
performed. In such cases, delete a paired device
first. Refer to Deleting a paired device. on the pre-
vious page.
4 Use your Bluetooth device to establish
a connection.
The connection method is different depending
on the Bluetooth device. Refer to the manual
for your Bluetooth device to establish a con-
nection.
While connecting, Pair your phone is dis-
played. If the connection is established,
Paired is displayed.
# If the connection fails, Connection Error is
displayed. In such cases, try again from the be-
ginning.
# The PIN code is set to 0000 as the default, but
can be changed. Refer to Entering PIN code for
Bluetooth wireless connection on the next
page.
42
En
Connecting to a Bluetooth
device automatically
(Function of AVH-P5250BT)
If this function is set to on, a connection be-
tween your Bluetooth device and this unit will
take place automatically as soon as the two
devices are less than a few meters apart.
Initially, this function is set to on.
1 Display the Bluetooth Connection
Menu.
Refer to Introduction of Bluetooth telephone op-
erations on page 24.
2 Touch Auto Connect to turn automatic
connection on.
If your Bluetooth device is ready for a Blue-
tooth wireless connection, a connection to
this unit will automatically be established.
# To turn automatic connection off, touch
Auto Connect again.
3 Turn your vehicle's ACC switch off and
on.

Switching visible unit

(Function of AVH-P5250BT)
This function sets whether or not to make this
unit visible to the other device.
Initially, this function is set to on.
1 Display the Bluetooth Connection
Menu.
Refer to Introduction of Bluetooth telephone op-
erations on page 24.
2 Touch Visibility to select visibility off.
! To turn visibility on, touch Visibility
again.
Displaying BD (Bluetooth
Device) address
(AVH-P5250BT only)