Panasonic DP-C266 Operating Instructions Manual page 218

Info. Code
638 Power failure occurred during
the communication.
700 During dialing, the Stop key was
pressed.
711 Incorrect LDAP settings
712 Incorrect Email address
714 Cannot log on to the LAN.
715 TCP/IP connection timed out.
716 Cannot log on to the designated
SMTP server.
717 Incomplete SMTP Protocol
transmission. SMTP server's
hard disk may be full.
719 Received data via LAN is in a
format that is not supported.
720 Cannot connect to the POP
server (incorrect POP server IP
Address). POP server is down.
721 Cannot connect to the POP
server (user name or password
error).
722 Failed to obtain IP Address from
the DHCP server.
725 DNS server connection timed
out. DNS server is down.
218
Problem
Check the power cord and plug.
Reload the document and send again.
Check the LDAP server name, LDAP log-in
name, LDAP password, and LDAP search
base.
Check the registered Email address.
Check the IP Address of the SMTP server with
the network administrator.
An unexpected LAN problem occurred. Check
the 10 Base-T/100 Base-TX/1000 Base-T cable
connection. Contact the network administrator.
Check the Internet Fax parameter settings.
Verify the IP Address, Default Gateway IP
Address, and SMTP server IP Address.
Check the SMTP server IP Address setting.
Contact the network administrator.
SMTP server is defective.
Contact the network administrator.
Ask the originator to re-send with a supported
file attachment format:
• In the TIFF-F format
• Image data conforming to recording paper
size
Check the POP server IP Address.
Contact the network administrator.
Check the POP user name and password, or
the APOP settings.
Contact the network administrator.
Check the 10 Base-T/100 Base-TX/1000
Base-T cable connection.
Confirm that the Internet Parameter, and the
DHCP server are correctly configured before
turning on, or turning off the power.
Contact the network administrator.
Check the DNS server IP Address.
Contact the network administrator.
Action Refer to
Operating
Instructions (For
Function
Parameters)
Operating
Instructions (For
Administrator
Setup)
Operating
Instructions (For
Administrator
Setup)
Operating
Instructions (For
Administrator
Setup)
Operating
Instructions (For
Administrator
Setup)
Operating
Instructions (For
Administrator
Setup)
Operating
Instructions (For
Administrator
Setup)
Operating
Instructions (For
Administrator
Setup)
Operating
Instructions (For
Administrator
Setup)