Lcd Panel - Packard Bell EasyNote SB Series Disassembly Manual

5. Remove two screws located near the edges on the rear side bottom of
the unit.
6. Remove the two screws from the rear side of the unit.
7. Remove the 2 hinge covers. You can leverage them loose with a small
flathead screwdriver.
8. Open the LCD panel to an upright position (90 degree angle with the
base unit) and lift the panel out.
Note: Pull the WLAN antenna and LCD cable through the hole in the top cover one by one
(there is no room to pull them through at the same time). During disassembly, it is easiest to
first put the LCD cable back and the WLAN antenna second to ensure the WLAN antenna is
guided to the right place.

LCD Panel

1. Remove the LCD Assembly as described above
2. Remove the 6 rubber stoppers in the LCD bezel.
Note: the 2 rubber stoppers used on the upper corners are different from the other 4 rubbers.
3. Remove the screws in the bezel.
Fig. 20 The bottom of the notebook.
EasyNote SB Disassembly Manual 14