Table of Contents
Advertisement
Chapter 2: Installation
To install WD Array Management Setup (AMS) is an uncomplicated procedure, once you
understand your systems and how you want to use AMS. The purpose of this Chapter is to
help you plan and carry out your installation of AMS.
By way of review, AMS consists of three components:
Monitoring Utility
!
Message Server
!
Message Agent
!
These were described in the previous chapter. Before proceeding with the installation, you
must know which component goes where. If you plan to run AMS over a network, you must
know the IP addresses of each computer on the network that will be involved in your RAID
monitoring and management activity.
Installation Locations
In the table below are possible locations for each of the three AMS components.
Internet-connected PC
Network PC
Network File Server
RAID PC
Monitoring Utility
The Monitoring Utility installs on any computer you will use to monitor and manage the
RAIDs.
If your RAID runs without a network connection, install it on the RAID PC with the rest of
the AMS components.
If your RAIDs are networked, you can install the Monitoring Utility on any computer
connected to the network.
If your company has networked RAIDs and Internet access, you may choose to install the
Monitoring Utility on a laptop or home-based PC for dial-in remote access.
Monitoring Utility
Table 1. Acceptable AMS Component Installation Locations
WD ARRAY MANAGEMENT SETUP
Message Server
•
•
•
•
•
•
•
CHAPTER 2: INSTALLATION - 4
USER MANUAL
Message Agent
•
Advertisement
Table of Contents
