Table of Contents
Advertisement
UCM Programming and Operation
Chapter Overview
This chapter contains information about the following:
•
•
•
•
•
•
Accessing Rover/Comm4
Rover Overview
Rover is a service tool that allows parameters to be viewed or adjusted in UCM v 2.0 and higher.
Prior to UCM v 2.0, you would need to use EveryWare to access units that were stand alone. The
operating and programming guide for Rover is EMTX-SVX01*-EN. Rover Comm4 is a software
application for monitoring, configuring, and testing VAV II/III/IV controllers on Comm4 links. Rover
Comm4 replaces Every Ware service software.
Note: For Instructions on how to use Rover Comm4, refer to the Rover Comm4 online Help by
Laptop Requirements and Complete Connection Instructions
For instructions on connecting a PC laptop to a Comm4 link, refer to the Installing Rover Service
Tool Version 5.0, 3270 3275.
Note: A hard copy of this document is in the Rover package and an electronic copy
To connect to a Comm4 Link
1. Insert the Comm4 card in the PC laptop.
2. Connect the cables as shown in the appropriate figure. Refer to
Figure 15. Connecting to a Comm4 controller through a zone sensor.
30
Accessing Rover/Comm4
UCM Home Tabs: At a Glance
UCM Home Tabs: Instructions
Entering and Exiting the Service Mode
Overriding VAVs
Resetting Diagnostics
clicking Contents and Index on the Help menu.
(Installation.pdf) can be found on the Rover installation CD-ROM.
to a Comm4 controller through a zone sensor and
controller using alligator clips.
Note: Make sure to maintain polarity.
Adapter cable
RJ11
plug
Figure 15, p. 30
Figure 16, p. 31
for Connecting to a Comm4
Comm4
PCMCIA card
for connecting
VAV-SVX01C-EN
Hide quick links:
Advertisement
Table of Contents
