TP-Link TL-WA701ND User Manual page 37

1) Access Point: This mode allows wireless stations to access this device.
SSID (Set Service Identifier) - Identifies your wireless network name. Create a name up to 32
characters and make sure all wireless points in the wireless network with the same SSID. The
default SSID is TP-LINK_XXXXXX (XXXXXX indicates the last unique six characters of each
device's MAC address). This value is case-sensitive. For example, TEST is NOT the same as
test.
Region - Select your region from the pull-down list. This field specifies the region where the
wireless function of the device can be used. It may be illegal to use the wireless function of
the device in a region other than one of those specified in this field. If your country or region
is not listed, please contact your local government agency for assistance.
When you select your local region from the pull-down list, click the Save button, then the
Note Dialog appears. Click OK.
Note:
Limited by local law regulations, version for North America does not have region selection
option.
Channel - Determines the operating frequency to be used. It is not necessary to change the
wireless channel unless you notice interference problems with another nearby access point.
Mode - Select the desired wireless mode. The options are:
•
11b only - Only 802.11b wireless stations can connect to the device.
•
11g only - Only 802.11g wireless stations can connect to the device.
•
11n only - Only 802.11n wireless stations can connect to the device.
•
11bg mixed - Both 802.11b and 802.11g wireless stations can connect to the device.
TL-WA701ND
Figure 4-10 Wireless Settings in Access Point mode
Note Dialog
150Mbps Wireless N Access Point User Guide
29