Starting Warm Engine - Echo SRM-225 Operator's Manual

SRM-225
Move choke lever (B) to Cold Start Position (
3. Purge Bulb
Pump purge bulb (C) until fuel is visible and flows freely in the
clear fuel tank return line. Pump bulb an additional 4 or 5
times.
4. Recoil Starter
Lay the unit on a flat area and keep movable attachment parts
clear of all obstacles. Firmly grasp right hand grip and throttle
trigger lockout with left hand and fully depress throttle trigger
to wide open position. Rapidly pull recoil starter handle/rope
(D) until engine fires (or maximum five [5] pulls).
5. Choke
After engine fires (or 5 pulls), move choke lever back to Run
( ) position. Hold throttle trigger and throttle trigger lockout
fully depressed, and pull recoil starter starter handle/rope until
engine starts and runs. Release throttle trigger, and allow unit
to warm up at idle for several minutes.
Note: If engine does not start with choke in "Run" position after
5 pulls, repeat instructions 2 - 5.
6. Throttle Trigger
After engine warm-up, gradually depress throttle trigger to
increase engine RPM to operating speed.

Starting Warm Engine

The starting procedure is the same as Cold Start except DO
NOT close the choke, and do not hold throttle trigger fully
depressed.
The attachment should not move at idle, otherwise serious
personal injury may result.
Note: If attachment moves, readjust carburetor according to
"Carburetor Adjustment" instructions in this manual or
see your ECHO Dealer.
1. Stop Switch
X7722271108
© 03/2013 ECHO Inc.
).
B
C
D
OPERATION
A
19