Lubrication; Nylon Line Head Disassembly Instructions - Echo SRM-225 Operator's Manual

MAINTENANCE

Lubrication

Level 1.
Parts Required:
POWER BLENDX
Lithium Base Grease.
Gear Housing
1. Clean all loose debris from gear box.
2. Remove plug (A) and check level of grease.
3. Add grease if necessary. DO NOT over-fill.
Drive Shaft (flex cable models)
1. Loosen two (2) screws (B) and remove center locating screw (C). Pull gear box and shield from drive
shaft housing.
2. Pull flexible cable from the drive shaft housing, wipe clean and re-coat with a thin coating [15 ml (1/2
oz.)] of grease.
3. Slide the flexible cable back in the drive housing. DO NOT get dirt on the flex cable.
4. Install the gear housing and shield assembly.
Flat edge of washers (D) must be against drive shaft.

Nylon Line Head Disassembly Instructions

Note: For normal use, Speed Feed© head disassembly is not
necessary. However, if circumstances require
disassembly, follow these instructions.
1. Press top of locking tabs (A) on both sides of Speed
Feed© head to release cover (B) from eyelet carrier(C).
2. Remove cover from eyelet carrier.
26
8 oz. (P/N 91014) or
TM
B
D
A
C
SRM-225
C
A
B
X7722271108
© 03/2013 ECHO Inc.