Table of Contents
Advertisement
•
Target IP Addresses
•
Add
•
Remove
Going Online
Description
In order to control DX hardware devices you must go online. Going online causes DX
Navigator to communicate with all devices that are available through the selected
Communications
protocol, and list all devices it discovers in the Found Devices tab. Once
device(s) are found, DX Navigator continuously monitors the status of each device connection.
Double-clicking the Device Icon of any online device then allows you to login to and open the
unit's Device Window.
broadcasting, thus allowing DX Navigator to find DX devices
within secured networks. In most networks Specify Target IP
Addresses should be used whenever the computer and DX
device(s) are connected to different subnets.
When
Specify Target IP Addresses is selected, DX
Navigator polls only those units whose IP addresses are listed in
the Target IP Addresses list. DX units present on the network but
whose IPs are excluded from this list are not polled, and therefore
will not appear in the Found Devices list.
Adds the [IP Address] specified in the IP Address text box to the
Target IP Addresses list.
Removes the selected [IP Address] from the Target IP Addresses
list.
7
Advertisement
Table of Contents
