Dodge 2009 Aspen Owner's Manual page 100

98 MAINTAINING YOUR VEHICLE
Adding Coolant
Your vehicle has been built with an improved TPIM
coolant that allows extended maintenance intervals. This
coolant can be used up to 5 Years or 102,000 miles (170
000 km) before replacement. To prevent reducing this
extended maintenance period, it is important that you
use the same coolant throughout the life of your vehicle.
Please review these recommendations for using Hybrid
Organic Additive Technology (HOAT) coolant. When
adding coolant:
• The
manufacturer
Antifreeze/Coolant 5 Year/100,000 Mile Formula
HOAT (Hybrid Organic Additive Technology)
• Mix a minimum solution of 50% HOAT engine coolant
and distilled water. Use higher concentrations (not to
exceed 70%) if temperatures below -34°F (-37°C) are
anticipated.
recommends using Mopar
• Use only high purity water such as distilled or deion-
ized water when mixing the water/TPIM coolant
solution. The use of lower quality water will reduce
the amount of corrosion protection in the engine
cooling system.
Please note that it is the owner's responsibility to main-
tain the proper level of protection against freezing ac-
cording to the temperatures occurring in the area where
the vehicle is operated.
NOTE: Mixing coolant types will decrease the life of the
TPIM coolant and will require more frequent coolant
changes.
TPIM Cooling System Pressure Cap
The cap must be fully tightened to prevent loss of
coolant.
The cap should be inspected and cleaned if there is any
accumulation of foreign material on the sealing surfaces.