Table of Contents
Advertisement
heater control switch is activated. The heater may emit a slight,
harmless odor when first used. This odor is a normal condition
caused by initial heating of internal heater parts and will not occur
again.
Resetting The Temperature Cutout Switch
The heater on this fireplace is protected with a safety device to prevent
overheating. Should the heater overheat, an automatic cutout will turn
the heater off and it will not come back on without being reset. It can
be reset by switching the Main Power Switch (FIGURE 3) to Off and
waiting 5 minutes before switching it to On. The remote control will
need to be re-initialized. (See page 3)
CAUTION: If you need to continuously reset the heater, disconnect
the power at the main service panel and call your local dealer
Maintenance
WARNING: Disconnect all power coming to fireplace at main service
panel before attempting any maintenance or cleaning to reduce risk
of fire, electric shock or damage to persons.
Light Bulb Replacement
Light bulbs need to be replaced when you notice a dark section of the
flame of when the clarity. There are four bulbs under the log set which
generate the flames and embers.
NOTE: Allow at least five minutes for light bulbs to cool off before
touching bulbs to avoid accidental burning of skin.
Helpful Hints
It is a good idea to replace all light bulbs at one time if they are close to
the end of their rated life. Group replacement will reduce the number
of times you need to open the unit to replace light bulbs. Long life
bulbs are recommended to reduce the frequency of bulb changes.
Bulb Requirements: Quantity of 4 clear chandelier or candelabra
bulbs with an E-12 (small) socket base, 60 watt rating. Example:
5
Advertisement
Table of Contents
