Table of Contents
Advertisement
ef
EDS7001F MILANO
RESETTING THE TEMPERATURE CUTOFF SWITCH
This unit is equipped with a thermostat that controls the temperature of the room.
It does this by turning the heater on and off. The heater is protected with a safety
device to prevent overheating. Should the heater overheat, an automatic cut out
will turn the heater off and it will not come back on without being reset. To reset
the temperature cutoff switch turn the main power switch to the OFF position and
wait five minutes before switching the unit back on.
Figure 1
OPTIONAL REMOTE CONTROL USAGE
1. Plug the stove into the outlet located on the
side of the receiver.
2. Plug the receiver into the wall outlet.
3. Install a 9 volt battery into the transmitter.
4. Turn the stove main power switch to the on
position prior to using the remote control.
5. The remote control works up to 50 feet away.
6. Push the ON button to turn stove on, push the
OFF button to turn the stove off.
NOTE:
To prevent the risk of fire, the stove plug must be
inserted fully into the receiver.
NOTE:
The remote control and receiver use one of 243
independent frequencies. When replacing the
remote control or the receiver they must be
replaced as a set to ensure proper operation.
The frequency of the remote is located on the
back of the remote on a label. (Figure 1)
4
Advertisement
Table of Contents
