Wall Mounted Controls; Resetting The Temperature Cutout Switch - Dimplex Electric Fireplace Practical User's Manual

WALL MOUNTED CONTROLS

The fireplace can be installed with wall-mounted
controls in addition to the controls provided.
These controls include wall switches and
thermostats.
A. Wall Mounted Thermostats
ALL MODELS WITH REMOTE CONTROL.
When the fireplace is set to Level 2, or Level 3 the
wall mounted thermostat will control the heat
output of the unit. When the fireplace is set to
Level 2, or 3 the heater will not activate until the
wall mounted thermostat senses an ambient
temperature lower than the temperature to which it
is set.
B. Wall Mounted Switches
ALL MODELS WITHOUT REMOTE CONTROL
ONLY.
This model may be installed such that a wall-
mounted switch activates the flame effect and a
wall mounted thermostat activates the heater.
RESETTING THE TEMPERATURE
CUTOUT SWITCH
The heater on this fireplace is protected with a
safety device to prevent overheating. Should the
heater overheat, an automatic cut out will turn the
heater off and it will not come back on without
being reset. It can be reset by switching the Main
Power switch (FIGURE 3) to OFF and waiting 5
minutes before switching it to ON. The remote
control will need to be re-initialized (see page 2)
CAUTION
If you need to continuously reset the
heater, disconnect the power at the main
service panel and call your local dealer.
NOTE
The heater may emit a slight, harmless
odor when first used. This odor is a
normal condition caused by initial heating
of internal heater parts and will not occur
again.
4