Battery Replacement; Remote Control - Dimplex DS4411 Owner's Manual

Operation
battery cover (Figure 2).

Remote Control

Initialization
1. Place the 3 Position Switch
(Figure 1a) in the oFF (" o ")
position.
2. Wait a minimum of five (5)
seconds and then place the 3
Position Switch in the Remote
position (" ").
3. Within 10 seconds of
changing the switch position,
press the on button located
on the remote control (Figure
2). This will synchronize the
remote control and the stove
receiver.
!
NOTE: You will have only 10
seconds to perform this last step.
Failure to do so will result in these
steps needing to be followed
again.
10

Battery Replacement

To replace the battery:
1. Slide battery cover open on
the remote control.
2. Correctly install one (1) 12
Volt (a23) battery in the
battery holder.
3. Close the battery cover.
Battery must be recycled
or disposed of properly.
Check with your Local
authority or Retailer for recycling
advice in your area.
www.dimplex.com