Switch Replacement - Dimplex CFP3913 Service Manual

Figure 5
Screws to
remove (12)
Do not remove
these 2 screws
Figure 6
Screws to
remove (7)
8. Remove the two (2) Phillips screws that attach the Mirror
Retaining Bracket in place (Figure 7) and remove.
9. Slide mirror up from within the firebox to remove.
10. Properly orientate replacement mirror and slide it down
into place behind Log Set.
11. Re-assemble firebox in reverse order as above.
Trim
Rear view of firebox
Figure 7
Mirror Retaining
Bracket
Mirror
Log Set

Switch Replacement

If the fireplace was operating prior to servicing allow at least
five (5) minutes for light bulbs and heating element to cool off
to avoid accidental burning of skin.
Disconnect power before attempting any maintenance or
cleaning to reduce the risk of electric shock or damage to
persons.
Each of the three (3) switches (3 Position On/Off Switch,
Low Heat Switch and High Heat Switch) will have the same
replacement procedure.
Replacement Procedure:
1. Pull fireplace away from the wall far enough to access
the back of the unit.
2. Remove one (1) Phillips screw from each of the two (2)
brackets which attach the upper part of the firebox to the
mantel, and remove the three (3) Phillips screws along
the bottom edge (Figure 4, page 6).
3. Tilt up the top portion of the firebox until the metal
Mounting Bracket clears the wood support of the mantel
(Figure 4).
4. Push the firebox insert out the front of the mantel.
5. Turn firebox on it's front and remove the 12 Phillips
screws that attach the Trim to the firebox (Figure 5).
6. Turn the unit upright and pull the Trim off of the firebox.
7. Remove the seven (7) screws that attach the Top Panel
to the firebox. There are: two (2) Phillips screws along
each side at the top edge of the firebox; and three (3)
Phillips screws at the back of the firebox, along the top
edge (7 in total) (Figure 6). Remove the Top Panel.
8. Remove the two (2) Phillips screws that attach the Mirror
Retaining Bracket in place (Figure 7) and remove.
9. Slide mirror up from within the firebox to remove.
10. Remove the Log Set by pulling it straight up and out of
7
Screws (2)