Viking FAXJ-1000 Technical Practice page 3

B. PABX / KSU Application
* Note:
C. Installing a FAXJ-1000 on a Residential Line
The FAXJ-1000 is designed to be wired at the Demarcation Point (the point where the phone line comes into the
house), but in some cases this may not be possible or convenient. This section shows a way of hooking up the FAXJ-
1000 to any existing phone jack, provided the house is wired for at least two lines. A splitter/adapter is required for each
jack in the house (ie: Radio Shack part # 279-402).
Step 1. The connection of the FAXJ-1000 to the telephone line can be at any extension wall jack. Unplug anything connected
to the selected jack and plug a splitter/adapter into the jack.
Step 2. Connect the CO LINE IN terminals of the FAXJ-1000 to the Line 1 port of the splitter/adapter. If the phone line is a
DSL line, a DSL filter should be installed as shown in the diagram below.
Step 3. Connect the PHONE 1 terminals of the FAXJ-1000 to the Line 2 port of the splitter/adapter.
Step 4. Unplug any phones at extension wall jacks located away from the FAXJ-1000 and plug in splitter/adapters.
Reconnect the phones to the Line 2 side of the splitter/adapters.
Note:
1.
2.
* Note:
VIKING
120V AC
13.8V AC
Adapter
(included)
RING DELAY
DISTINCTIVE RING
AUTO / MANUAL
1 2 3
* Earth Ground
(optional)
C.O. Line
PABX/KSU
FAXJ-1000
120V AC
13.8V AC
Adapter
(included)
Incoming Line
with DSL
DSL
Line 1
Modem
Splitter /
Adapter
Line 2
Phone 1
Line 1
Splitter /
Adapter
Line 2
Line 1
Splitter /
Phone 3
Adapter
Line 2
MODEL FAXJ-1000
©
VIKING
ELECTRONICS
HUDSON, WI 54016
PHONE/DATA/FAX SWITCH
1 2 3 4 5 6 7 8 9 10
STATUS
GND CO LINE IN PHONE 1 FAX MODEM PHONE 2
Fax
VIKING
MODEL FAXJ-1000
©
VIKING
ELECTRONICS
HUDSON, WI 54016
PHONE/DATA/FAX SWITCH
1 2 3 4 5 6 7 8 9 10
RING DELAY
DISTINCTIVE RING
AUTO / MANUAL
STATUS
1 2 3
GND CO LINE IN
* Earth Ground
(optional)
DSL Filter
Phone
Personal Computer
PHONE 1 FAX MODEM PHONE 2
Phone 2
Personal Computer
Fax
3