Viking FAXJ-1000 Technical Practice

Faxjack phone/fax switch
Hide thumbs Also See for FAXJ-1000:

Advertisement

Quick Links

TECHNICAL
TECHNICAL
T
T
E
L
E
E
L
E
The FAXJ-1000 stores and retransmits caller ID information so that it is truly caller ID
compatible.
F
e
a
t
u
r
e
s
F
e
a
t
u
r
e
s
• Four ports allow any four analog devices to
share a single line
• Routes calls via CNG tone, distinctive ringing,
touch tones sent by calling device or manually
• Provides realistic ring-back tones while re-ringing
selected device
• Transfer from one port to another as often as
may be required during the same call
• Caller ID information is stored and retrans-
mitted during transfer
• Automatic "privacy" eliminates interruptions on
both in and outbound calls
• Monitors for calling party control (CPC)
• All in and outbound calls are routed to the phone 1
port during a power failure
• Manual mode will not interfere with C.O. provided
voice mail
• Ports are balanced to prevent noise on long
runs
• Compatible with high-speed modems
• Surge protection on both power and phone line
• Internal Call Mode
S
S
C
O
M
O
L
U
T
I
O
N
S
C
O
M
O
L
U
T
I
O
N
S
Eliminate the Expense of
Dedicated Phone Lines!
2
1
C
2
1
C
F
O
R
T
H
E
S
T
F
O
R
T
H
E
S
T
The FAXJ-1000 allows any business, large or
small, to enjoy the convenience of automated
data transmission without the perpetual monthly
expense of a dedicated phone line.
The FAXJ-1000 is a versatile phone/data/fax
switch with the ability to automatically route calls
via fax CNG tone, central office distinctive ring,
or touch tones included in the dial string by the
calling party. In addition, the FAXJ-1000 offers
full manual transfer capabilities.
A
p
p
l
i
A
p
p
l
Fax Machines
• Retail
• Commercial
• Industrial
Modem Terminals
• Personal computers
• Vending machines
• Remote access applications
Point-Of-Sale Terminals
• Fast food chains
• Retail stores
• Convenience stores
S
p
e
c
S
p
e
c
Power: 120V AC/13.8V AC 1.25A, UL listed adapter provided
Dimensions: 133mm x 91mm x 44mm (5.25" x 3.6" x 1.75")
Shipping Weight: 1.36 kg (3 lbs)
Environmental: 0°C to 32°C (32°F to 90°F) with 5% to 95% non-
condensing humidity
CNG Detection: 1100 Hz burst
Maximum Data Speed: 56 Kbps
Minimum CPC Time: 320ms
Ring Output: 4 REN, capable of ringing (8) 0.5 REN phones
REN: 0.7A
Connections: (1) 10-position cage clamp terminal strip
FAXJ-1000
FAXJ-1000
Phone/Fax Switch
December 14, 2011
E
N
T
U
R
Y
E
N
T
U
R
Y
c
a
t
i
o
n
s
i
c
a
t
i
o
n
s
• Governmental
• Home office
i
f
i
c
a
t
i
o
n
s
i
f
i
c
a
t
i
o
n
s
FaxJack

Advertisement

Table of Contents
loading

Summary of Contents for Viking FAXJ-1000

  • Page 1 In addition, the FAXJ-1000 offers full manual transfer capabilities. The FAXJ-1000 stores and retransmits caller ID information so that it is truly caller ID compatible. Fax Machines • Four ports allow any four analog devices to •...
  • Page 2 Viking Electronics, Inc., 1531 Industrial Street, Hudson, WI 54016 (715) 386-8666 VIKING A. Fax / Data / Phone Application MODEL FAXJ-1000 120V AC © VIKING Note: ELECTRONICS HUDSON, WI 54016 CO Line In PHONE/DATA/FAX SWITCH 13.8V AC Adapter (included) 1 2 3 4 5 6 7 8 9 10...
  • Page 3 Step 2. Connect the CO LINE IN terminals of the FAXJ-1000 to the Line 1 port of the splitter/adapter. If the phone line is a DSL line, a DSL filter should be installed as shown in the diagram below.
  • Page 4: Dip Switch Programming

    Step 2. Answer the ringing line using the phone (or device) connected to any of the device ports (this may take a few moments if the FAXJ-1000 is in the Automatic Answer mode). Enter , followed by 845464. Step 3.
  • Page 5: Automatic Answer Mode

    If caller ID is enabled, the FAXJ-1000 waits two seconds after the first CO (telephone company) ring to receive and store the caller ID data and then answers the line. If caller ID is disabled, it answers the line immediately after the first ring. The FAXJ-1000 then starts generating ringback tones to the caller every four seconds, while listening in the interval between ringbacks for fax CNG tones or Touch Tones to route the call (see Operation, section D for a description of how incoming touch tones can be used to route calls).
  • Page 6: Manual Answer Mode

    The Phone 1 port will continue to ring, subject to the Ring Limit (see Operation, section F). If the call is answered by the Phone 1 port and a fax CNG tone is detected, the FAXJ-1000 provides a busy signal to Phone 1 and starts ringing the call to the FAX port.
  • Page 7: Internal Calls

    E. Internal Calls The internal call mode gives you the ability to create an “internal” call from one port of the FAXJ-1000 to any other port. This allows the phones behind the FAXJ-1000 to selectively call any phone on another port and communicate with that phone. When the two ports are connected together, the telephone line is disconnected so you don’t hear busy signals, re-order tones or intercept mes-...
  • Page 8: Distinctive Ringing

    Modem port Due to the dynamic nature of the product design, the information contained in this document is subject to change without notice. Viking Electronics, and its affiliates and/or subsidiaries assume no responsibility for errors and omissions contained in this information. Revisions of this document or new editions of it may be issued to incorporate such changes.

Table of Contents