Maintenance and service
Replacing bulbs
Dipped beam, main beam,
position/parking lamp and side
marker light
The entire lamp insert must first be
removed when replacing dipped beam, main
beam and position/parking lamp bulbs. To
replace one of these bulbs, do the following and
then consult the instructions for the specific
lamp.
1. Switch off all lights and turn ignition key to
position 0.
2. Open the bonnet.
3. Release the insert by pulling up the two
lock pins holding it in place.
4. Lift the insert straight out.
148
5. Unplug the connector by first pressing in
the catch from underneath and then pulling
it up a bit from above.
6. Lift out the entire headlamp insert and
place it on a soft surface so as not to
damage the lens.
Refit the headlamp insert in reverse order.
Check that the lock pins are correctly situated.
1
2
5
4
Location of bulbs in front lamp
1. Dipped beam
2. Main beam
3. Direction indicator
4. Position/Parking lamp
5. Side marker light
3