Load On The Roof - Volvo XC90 Owner's Manual

Load on the roof

Load carrier placement
(accessory)
Make sure that the load carrier is placed in the
right direction on the roof rails. Load carriers
can be placed along the entire roof rail. When
driving without a load, the front load carrier
should be situated about 200 mm in front of the
centre rail base and the rear load carrier should
be between the centre and the rear rail base (see
above illustration) to minimise wind noise. The
longer load carrier should be in the front.
Fitting load carriers
Make sure that the load carrier sits correctly
against the roof rail. Screw on the load carrier
using its torque wrench. Tighten to the marking
on the torque wrench (corresponds to 6 Nm).
See illustration!
Starting and driving
Load carrier cover
Use the end of the torque wrench (see illus-
tration) or the ignition key to loosen or secure
the cover. Rotate ¼ turn.
119