Homelink Eu - Volvo V50 Owner's Manual

General
HomeLink is a programmable remote control
which can control up to three different devices
(e.g. garage door, alarm system, outdoor light-
ing and indoor lighting etc.) and in doing so
replace their remote controls. HomeLink is
supplied built into the left-hand sun visor.
HomeLink's panel consists of three program-
mable buttons and one indicator lamp.
NOTE
HomeLink is designed to be inoperable if
the car is locked from the outside.
Save the original remote controls for future
programming (e.g. for purchasing a new
car).
Erase the programming for the buttons
when selling the car.
Metallic sun visors should not be used in
cars equipped with HomeLink. This could
have a negative effect on the HomeLink
function.
Operation
When HomeLink is fully programmed it can be
used in place of the separate original remote
controls.
Press the programmed button to activate the
garage door, alarm system etc. The indicator
lamp illuminates for the time that the button is
kept depressed.
NOTE
In the event that the ignition is not activated,
HomeLink operates for 30 minutes after the
driver's door has been opened.
The original remote controls can of course be
used in parallel with HomeLink.
02 Instruments and controls
WARNING
If HomeLink is used to operate a garage
door or gate, ensure that nobody is in the
vicinity of the door or gate while it is in
motion.
Do not use the HomeLink remote control for
any garage door that does not have safety
stop and safety reverse. The garage door
must react immediately when it detects that
something is preventing its movement, and
stop directly and reverse. A garage door
without these characteristics could cause
personal injury. For further information, ring
the HomeLink Hotline: 008000 466 354 65
(free of charge). They can also be contacted
via the Internet: www.homelink.com.
Programming for the first time
The first step erases the memory in HomeLink
and must not be carried out when only one
individual button is being reprogrammed.
1. Depress the two outer buttons and do not
release until the indicator lamp starts to
flash after approx. 20 seconds. The flash-
ing indicates that HomeLink is set in "learn
mode" and is ready to be programmed.
2. Position the original remote control 2-8 cm
from HomeLink. Monitor the indicator
lamp.
*
Option/accessory, for more information, see Introduction.

HomeLink EU*

02
77