Volvo V50 Owner's Manual page 212

on or the ignition key inserted into the ignition
switch.
Dipped beam
Removing the cover and bulb:
1. Undo the whole lamp housing, see
page 210.
2. Bend aside the catches and remove the
cover.
3. Unplug the connector from the bulb.
4. Release the spring clip securing the bulb.
Press it in/down.
5. Pull out the bulb.
Fitting a new bulb
1. Fit the new bulb. It can only fit in one posi-
tion.
2. Press the spring clip in/up and then slightly
to the right in order to snap it into position.
3. Press the connector back on.
4. Refit the plastic cover.
5. Refit the lamp housing, see page 210.
09 Maintenance and service
Replacing bulbs
Main beam, halogen
The illustration shows a halogen bulb.
1. Undo the whole lamp housing, see
page 210.
2. Undo the cover, located above the lamp
housing, by turning it anticlockwise.
NOTE
If the car has ABL or GDL bulbs then the
main beam bulb has another socket. In
which case, pull the bulb straight out.
3. Left-hand headlamp:
turn the bulb holder anticlockwise.
09
211