Led Definitions; Hardware Reset; Restoring Defaults - Vivotek PD8136 User Manual

LED Definitions

Item LED Status
1 Steady Red
Red LED off
2 Steady Red + blinking
for 1 sec and off for another)
Steady Red + Green
3 Blinking Red every 0.15 sec. + Blinking
(Red LED on for 0.15 sec. and
off for another)
4 Blinking Red every 0.15 sec. + blinking
sec.

Hardware Reset

The reset button is used to reset the system or to restore the factory default settings. Sometimes
resetting the system can return the camera to normal operation. If the system problems remain
after reset, restore the factory settings and install again.
Reset: Press and release the recessed reset button with a paper clip or thin object. Wait for the
Network Camera to reboot.
Restore: Press and hold the recessed reset button for a while to restore. Note that all settings
will be restored to factory default.
SD/SDHC/SDXC Card Capacity
This network camera is compliant with SD/SDHC/SDXC 32GB, 64GB, and other preceding
standard SD cards.
Green every 1 sec. (Green LED on
LED off
Green
Green LED on for 1 sec. and
Green
Description
Power on and system booting
Power off
Network heartbeat
Network disconnected
every 1 sec. Upgrading firmware
every 0.15

Restoring defaults

VIVOTEK
User's Manual - 7