Page 2
Warning Before Installation Power off the Network Camera Keep the Network Camera away assoon as smoke or unusual odors from water. If the Network Camera are detected. becomes wet, power off immediately. Do not place the Network Camera Do not place the Network Camera in around heat sources, such as a high humidity environments.
When installing the camera, orient the default front on the alignment sticker and the mounting plate (illustrated below) towards the area of your interest. The camera lens’ central position is aligned with the VIVOTEK logo on the dome cover. The Default Front...
Install MicroSD Card Open the MicroSD card plastic cover at the bottom using a small flathead screwdriver. Flip the socket cover forward and up. Insert a MicroSD card, close the cover, and push it back to secure the installation. Install the plastic cover by pressing it back to its original position.
Mounting the Network Camera 1. Attach base plate "A" of the ceiling mount bracket to the bottom of camera and secure it with two small round head screws. Note that the guiding edge of the base plate (where a screw hole is available) must protrude from the edge of camera. 2.
Network Deployment Power over Ethernet (PoE) When using a PoE-enabled switch This Network Camera is PoE-compliant, allowing transmission of power and data via a single Ethernet cable. Follow the below illustration to connect the camera to a PoE enabled switch via Ethernet cable. PoE Switch When using a non-PoE switch Use a PoE power injector (optional) to connect between the Network Camera and a...
2. The program will conduct an analysis of your network environment. After your network is analyzed, please click on the “Next” button to continue the program. 3. The program will search for VIVOTEK Video Receivers, Video Servers, and Network Cameras on the same LAN.