Track Editing; Copy & Paste And Move & Paste - Fostex VF08 Owner's Manual

Recorder Functions
Use the [JOG] dial to highlight (select) the desired pro-
2
gram and then press the [TIME BASE SEL/F2] key while
holding down the [SHIFT] key.
Now you can edit the title of the selected program.
The leftmost character of the selected program is blink-
ing.
<Hint>
You may use the [CURSOR >] to highlight "RENAME"
and press the [ENTER/YES] key to bring up the screen
above, instead of pressing the [TIME BASE SEL/F2] key
while holding down the [SHIFT] key.
Use the [CURSOR </>] keys to move the blinking (ed-
3
iting) point and use the [JOG] dial (or [CURSOR up/
down] keys) to select a character for the blinking point.
Because the VF08 uses a 3.5-inch E-IDE hard disk as the recording media, you can make non-linear and non-
destructive audio editing by track effectively.
Copy & Paste
The Copy & Paste function allows you to copy track
data of a desired part and paste it to a desired part of
the same or different track.
The copied data remains after pasting the data, so you
can paste the data as many times as required.
The copy & paste function is useful when using the
same musical part repeatedly in a song.
Copy & paste within the same track.
A
Copy & paste between different track.
START Point
END Point
<Notes>
• Copy data (or Move data) is replaced with the new data every time the copy (or move) operation is carried out.
• Note that copy data changes if you paste the copy data to the original data.
• The copy & paste (or move & paste) editing is performed on the current program. Therefore, do not change the current
program until the editing operations are completed.
Blinking

Track editing

A'
A'
TO Point
You can put a title name with up to 16 characters from
among those listed below.
When selecting a character, rotating the [JOG] dial while
holding down the [SHIFT] key jumps among characters
surrounded with the box below.
Press the [ENTER/YES] key after editing/entering the
4
title.
The edited/entered title is set.
Press the [EXIT/NO] (or [STOP]) key.
5
The display returns to the Normal screen.
Move & Paste
The Move & Paste function allows you to move track
data of a desired part and paste it to a desired part of
the same or different track.
Unlike the copy & paste operation, the moved data
does not remain in the original position.
Move & paste within the same track.
A
Move & paste between different track.
START Point
END Point
58
A'
A'
TO Point