Table of Contents
Advertisement
2-4. RECORD
Under Record menu, Record configuration options for Storage, Record and Record Tools can be
selected.
2-4-1. MENU > RECORD > Storage
In Storage, it displays the installed/connected storage status such as Capacity, Type, Usage and
Status.
Format: Press Format to format selected HDD.
Record: Displays the recording period and data stored on HDD.
Detail: Displays the detail information of data stored on HDD
Note
: The unit will start and record automatically when turn on the ignition if it is installed
properly. It will take about 20-30 seconds for the boot up and start recording based on the pre
set up options.
If the temperature below -0°C (32°F), the unit will start recording after HDD is heat up by our
built in heating sensor. If SD card is installed with HDD. It will start recording on SD Card while
HDD is being heat up. Once HDD is ready to record the data, it will stop the recording on SD
and automatically starts recording data on HDD.
Note
: Any changes or mis-installation of HDDs will stop mirroring and turn the system into
recording only mode.
In S.M.A.R.T, HDD status are being displayed
including its temeprature. Click Update to get
the latest status.
Mirroring allows recording data on two HDDs
simultaneously. This will prevents unexpected
lose of recording data due to HDD or system
failure.
31
Advertisement
Table of Contents
