5-Pin Xlr Dmx Connectors; System Menu - American DJ Quad Gem DMX User Instructions

Table of Contents

Advertisement

Quad Gem DMX™

5-Pin XLR DMX Connectors.

connectors for DATA transmission in place of 3-pin. 5-pin XLR fixtures
may be implemented in a 3-pin XLR DMX line. When inserting stan-
dard 5-pin XLR connectors in to a 3-pin line a cable adaptor must be
used, these adaptors are readily available at most electric stores. The
chart below details a proper cable conversion.
3-Pin XLR to 5-Pin XLR Conversion
Conductor
3-Pin XLR Female (Out)
Ground/Shield
Data Compliment (- signal)
Data True (+ signal)
Not Used
Not Used
American DJ
- www.americandj.com - Quad Gem DMX™ Instruction Manual Page 7
®
Some manufactures use 5-pin XLR
5-Pin XLR Male (In)
Pin 1
Pin 1
Pin 2
Pin 2
Pin 3
Pin 3
Pin 4 - Do Not Use
Pin 5 - Do Not Use
Set Up
Quad Gem DMX™
ADDR -
DMX Address Setting.
1. Tap the either the MENU, UP, or DOWN buttons until "ADDR"
is displayed, press ENTER.
2. "1" will now be displayed and flashing. Press the UP or
DOWN buttons to find your desired address. Leave the display
on this address, and after a few seconds the address will be
saved into memory.
CHND -
This will let you switch between 4 Channel DMX
mode and 7 Channel DMX mode.
1. Tap the either the MENU button until "CHND" is displayed,
press ENTER. Either "4 CH" or "7 CH" will be displayed
2. Tap the UP or DOWN buttons to choose your desired DMX
mode and press ENTER to confim and exit.
SLND -
This will let you set unit as a master or slave in a
master/slave configuration.
1. Tap the either the MENU button until "SLND" is displayed,
press ENTER. "MSTR", "SL 1" or "SL 2" will be displayed.
2. Tap the UP or DOWN buttons until your desired setting is
displayed, press ENTER to confim and exit.
SHND -
in this mode you can choose your desired sound
active show or an preset program. Note: Only shows 4 & 6
are preset programs.
1. Tap the either the MENU button until "SHND" is displayed,
press ENTER. If you cannot find this setting in the menu it
means that the unit is set as a "Slave". The unit must be set as
a "Master" to choose a desired sound active show.
American DJ
- www.americandj.com - Quad Gem DMX™ Instruction Manual Page 8
®

System Menu

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents