Advertisement

User Instructions
5/10
American DJ
®
6122 S. Eastern Ave.
Los Angeles CA. 90040
www.americandj.com
Hyper Gem LED™
Unpacking:
Thank you for purchasing the Hyper Gem LED™ by
American DJ
. Every Hyper Gem LED™ has been thoroughly tested
®
and has been shipped in perfect operating condition. Carefully check
the shipping carton for damage that may have occurred during ship-
ping. If the carton appears to be damaged, carefully inspect your fix-
ture for any damage and be sure all equipment necessary to operate
the unit has arrived intact. In the event damage has been found or parts
are missing, please contact our toll free customer support number for
further instructions. Please do not return this unit to your dealer with-
out contacting customer support first.
Introduction:
The Hyper Gem LED™ is a DMX intelligent LED fixture.
When using DMX mode you can choose between a four channle mode
and a 10 channel mode. The fixture can operate in three different oper-
ating modes; stand alone, sound-active, or in a Master/Slave configu-
ration. The Hyper Gem LED™ comes with several built in programs.
When used as a stand alone unit or when used in multiples linked in a
master/slave configuration. For best results use fog or special effects
smoke to enhance the beams projections.
Customer Support:
American DJ
support line, to provide help and to answer any question should you
encounter problems during your set up or initial operation. You may
also visit us on the web at www.americandj.com for any comments or
suggestions. Service Hours are Monday through Friday 9:00 a.m. to
5:00 p.m. Pacific Standard Time.
Voice:
(800) 322-6337
Fax:
(323) 582-2941
E-mail:
support@americandj.com
To purchase parts online visit http://parts.americandj.com
Warning!
To prevent or reduce the risk of electrical shock or fire, do
not expose this unit to rain or moisture.
Warning!
This may cause severe eye damage. Avoid looking directly
into the light source at all times!
American DJ
- www.americandj.com - Hyper Gem LED™ Instruction Manual Page 2
®
General Information
provides a toll free customer
®

Advertisement

Table of Contents
loading

Summary of Contents for American DJ Hyper Gem LED

  • Page 1 10 channel mode. The fixture can operate in three different oper- ating modes; stand alone, sound-active, or in a Master/Slave configu- ration. The Hyper Gem LED™ comes with several built in programs. When used as a stand alone unit or when used in multiples linked in a master/slave configuration.
  • Page 2: General Instructions

    Allow about 6” (15cm) between this device and a wall. • Do not attempt to operate this unit, if it becomes damaged. The Hyper Gem LED™ carries a 3 year (1095 days) limited warranty. • This unit is intended for indoor use only, use of this product out- Please fill out the enclosed warranty card to validate your purchase doors voids all warranties.
  • Page 3 Figure 1 Figure 4 standard 110-120 Ohm shielded cable (This cable may be purchased at American DJ - www.americandj.com - Hyper Gem LED™ Instruction Manual Page 5 American DJ - www.americandj.com - Hyper Gem LED™ Instruction Manual Page 6 ®...
  • Page 4: System Menu

    Pin 4 - Do Not Use Not Used Pin 5 - Do Not Use American DJ - www.americandj.com - Hyper Gem LED™ Instruction Manual Page 7 American DJ - www.americandj.com - Hyper Gem LED™ Instruction Manual Page 8 ® ®...
  • Page 5 01. Tap the MENU button until “SHND” is displayed, press level. 0 for least sensitive, 100 for more sensitive. American DJ - www.americandj.com - Hyper Gem LED™ Instruction Manual Page 9 American DJ - www.americandj.com - Hyper Gem LED™ Instruction Manual Page 10 ®...
  • Page 6 2. Press the UP button to select “DSP i” to activate this function, or “I DSP” to deactivate this function. 3. Press ENTER to confirm. American DJ - www.americandj.com - Hyper Gem LED™ Instruction Manual Page 12 American DJ - www.americandj.com - Hyper Gem LED™ Instruction Manual Page 11 ®...
  • Page 7: Stand-Alone Operation

    XLR connector only - The last unit in the chain will use 1. The Hyper Gem LED™ has two DMX Channel modes. A four the male XLR connector only. For longer cable runs we suggest a channel mode and a 256 channel mode.
  • Page 8 LED slow blinking LED fast blinking (LED OFF) (LED ON) Hyper Gem LED™ 256 Channel DMX Mode American DJ - www.americandj.com - Hyper Gem LED™ Instruction Manual Page 15 American DJ - www.americandj.com - Hyper Gem LED™ Instruction Manual Page 16 ® ®...
  • Page 9: Troubleshooting

    Periodic cleaning will ensure longevity, and crisp output. of the product; if the product has been repaired or serviced by anyone other than the American DJ, Inc. factory unless prior written authorization was issued to purchaser by American DJ, Inc.; if the 1.
  • Page 10: Specifications

    Web: www.americandj.com / E-mail: info@americandj.com American DJ Europe Junostraat 2 6468 EW Kerkrade Netherlands 4000358 service@americandj.eu / www.americandj.eu Tel: +31 45 546 85 00 / Fax: +31 45 546 85 99 American DJ - www.americandj.com - Hyper Gem LED™ Instruction Manual Page 19 ®...

Table of Contents