System Menu - American DJ Duo Scan RG User Instructions

Duo Scan RG System Menu Chart Duo Scan RG

System Menu

System Menu: When confirming your setting press ENTER
and then hold MENU for at least 2-3 seconds, or you can
wait 1 minute for automatic setup. To exit without making
any adjustments press the MENU button.
ADDR
- DMX Address Setting.
1. Press the MENU button until "ADDR" is displayed, press ENTER.
2. "X" will now be displayed, "X" represents the displayed address.
Press the UP or DOWN buttons to find your desired address.
3. Press ENTER to confirm, then connect your DMX controller.
NOTE: If after you connect your DMX controller the unit does not
fall into DMX mode, press and hold the MENU button for at least 3
seconds.
SLND -
This will let you set unit as a master or slave in a
master/slave configuration.
1. Press the MENU button until "SLND" is displayed, press ENTER.
Either "SL 1" or "SL 2" will be displayed.
2. Press the UP or DOWN buttons until your desired setting is dis-
played, press ENTER and then hold MENU for at least 2-3 seconds
to confim.
NOTE: In a Master/Slave configuration you can make one fixture the
Master and then set the next fixture to "SL 2", the fixtures will now
have contrast movement to each other.
SHND: SH 0 - SH5
- Show modes 0-5 (Factory programs).
Show mode can run with or without sound active mode
on. With sound active mode on, the shows will tend to run
faster.
1. Press the MENU button until "SHND" is displayed, press ENTER.
2. "Sh X" will now be displayed, "X" representing a number between
0-5. Programs 1-5 are preprogrammed shows, while "Sh 0" is random
show mode. Press the UP or DOWN buttons to find your desired show.
American DJ - www.americandj.com - Duo Scan RG Instruction Manual Page 11 American DJ - www.americandj.com - Duo Scan RG Instruction Manual Page 12
© ® © ®