Operating The Homelink Universal Transceiver; Rolling Code Programming - Ford 1999 Explorer Owner's Manual

Controls and features

Operating the HomeLink Universal Transceiver

Once programmed, the HomeLink
Universal Transceiver can be used in
place of hand-held transmitters. To
operate, simply press and release
the appropriate HomeLink button
(the red light will illuminate,
indicating the signal is being
transmitted).

Rolling code programming

Rolling code garage door openers (or other rolling code devices) which
are "code protected" and manufactured after 1996, may be determined
by the following:
• Reference the device owner's manual for verification
• The hand-held transmitter appears to program the HomeLink
Universal Transceiver but does not activate the device.
• Press and hold the trained HomeLink button. The device has the
rolling code feature if the indicator light flashes rapidly and then turns
solid after 2 seconds.
After completing the "Programming" functions, follow these steps to
train a garage door opener with the rolling code feature:
1. Locate the training button on the garage door motor head unit.
Refer to the garage door opener manual or call 1–800–355–3515 or on
the Internet at HomeLink.jci.com. if there is difficulty locating the
training button.
2. Press the training button on the garage door motor head unit (which
will activate the "training" light.)
3. Press and release the
programmed HomeLink button.
Press and release the HomeLink
button a second time to complete
the training process. (Some garage
door openers may require this
procedure to be done a third time
to complete the training).
94
REC DEL PLAY
REC DEL PLAY