Alcatel OmniAccess Wireless System 2.1 Product Manual page 644

Use MONITOR/Clients, click a list item under AP Name, click Registered Switch, then from the
Sidebar menu, under 802.11b/g, select RRM Grouping to access this page.
This page displays 802.11b/g RRM grouping parameters:
Table -
802.11b/g Grouping Control
Parameter
Grouping Algorithm
Group Leader MAC Address
Is 802.11b/g Group Leader
Last Update Time (secs)
Group Update Interval (secs)
Table -
Peer Group Members
Parameter
Peer MAC Address
Configure <IPaddr> > Interface
Use CONFIGURE/Switches and click an IP address under the IP Address column, on the left sidebar
menu, select System and click Interfaces to access this page.
This page allows you to view existing interfaces.
•
Checkbox: Select the interface to delete before using the Delete Dynamic Interfaces command.
•
Interface Name: User-defined name for this interface; for example, management, service-port,
virtual.
•
VLAN Identifier: VLAN Identifier between 0 (untagged) and 4096, or N/A.
•
Interface Type: Static or Dynamic.
11/5/04
90-100831-300 Rev 2Alcatel OmniAccess Wireless Access Point Quick Installation Guide 65
Dynamic grouping has two modes: on and off. When the grouping is
off, no dynamic grouping occurs. Each Alcatel OmniAccess Switch or
Appliance optimizes only its own OmniAccess AP 1200 or 1250's
parameters. When grouping is on, the Alcatel OmniAccess Switch or
Appliance forms groups and elects leaders to perform better dynamic
parameter optimization.
This is the MAC address of the group leader for the group containing
this Alcatel OmniAccess Switch or Appliance.
Yes, this Alcatel OmniAccess Switch or Appliance is the group leader
or No the Alcatel OmniAccess Switch or Appliance is not the group
leader. This leader is automatically determined by the OmniVista
AirView Software within the Alcatel Mobility Group as described in
the Alcatel OmniAccess Wireless Product Guide.
The elapsed time since the last group update in seconds. This is only
valid if this Alcatel OmniAccess Switch or Appliance is a group leader.
When grouping is on, this interval (in seconds) represents the period
with which the grouping algorithm is run by the Group Leader.
Grouping algorithm will also run when the group contents changes
and the automatic grouping is enabled. A dynamic grouping can be
started upon request from the system administrator. Default value is
3600 seconds.
MAC address of the peer(s).
Configure <IPaddr> > Interface
Configure <IPaddr> > Interface
Description
Description