Connecting An Onkyo Cassette Deck - Onkyo CR-725 Instruction Manual

Connecting Other Components—Continued

Connecting an Onkyo Cassette Deck

The following diagram shows how to connect an optional Onkyo cassette deck.
Connect the CD receiver's MD/TAPE OUT jacks to the cassette deck's INPUT (REC) jacks, and connect the CD
receiver's MD/TAPE IN jacks to the cassette deck's OUTPUT (PLAY) jacks.
CD receiver's
rear panel
LINE 1
IN
OUT
MD/
TAPE
IN
OUT
DOCK/
CDR
IN
R
: Signal flow
What can you do with
• Connecting an Onkyo cassette deck to the CD receiver with an
the CD receiver's remote controller. In addition, when playback is started on the cassette deck, the CD receiver will
automatically select it as the input source.
• To use , you must connect the Onkyo cassette deck to the CD receiver with an
(RCA). In addition, the Input Display for the MD/TAPE jacks must be set to "TAPE." Since this is the default setting,
unless you've changed it, it can be left as it is (see page 28).
• Some -capable components have two
is for connecting additional
Notes:
• When listening to the audio of a component connected to the CD receiver but with no
input source.
• It is also possible to connect the MD/TAPE jacks to a DAT recorder. When connected to a DAT recorder, set the Input
Display to "DAT" (see page 28).
• The MD/TAPE IN jacks can be connected to the audio output jack of a VCR. The VCR video output jack should be
connected to a TV. When the CD receiver is connected to a VCR, set the Input Display to "VIDEO" (see page 28).
Red
White
Analog audio cables (RCA)
White
Red
L
cable supplied with
the Onkyo cassette deck
?
jacks. They're both the same, so you can use either one. The extra jack
-capable components.
Onkyo cassette deck's
rear panel
INPUT OUTPUT
(REC) (PLAY)
L
R
White Red Red White
cable allows you to control the cassette deck with
cable and an analog audio cable
connection, select TAPE
REMOTE
CONTROL
19