Listening To The Radio; Tuning Into Fm /Am Radio Stations - Onkyo CR-545 Instruction Manual

Listening to the Radio

Tuning into FM /AM Radio Stations

When tuned into a station, the Tuned
indicator appears. When tuned into a stereo FM
station, the FM Stereo indicator appears as well.
AUTO
Band Frequency
Tuning into Weak Stereo FM Stations
If the signal from a stereo FM station is weak, it may
be impossible to get good reception. In this case,
switch to mono mode with [MODE] button and listen
to the station in mono.
1
Press the [TUNER] button repeatedly
to select "FM" or "AM".
"AM" is only for CR-545.
2 Press and hold down the [
[ ] buttons until frequency runs
and then release.
Once a station is found, tuning stops
automatically.
Radio frequency can be changed in 0.05
MHz steps for FM and 9 kHz step for AM.
34
FM Stereo
] /
Adjusting the Antennas
Adjusting and installing the DAB / FM
antenna
Choose a location for the FM antenna while listening
to an FM station. (For CR-545UKD, adjust the DAB
antenna in the same way.)
1
Change the direction of the antenna to achieve the
best reception.
2
(CR-545)
Affix the antenna with a thumbtack. (Do not push the
thumbtack through the antenna.)
Caution:
Be careful not to prick your finger!
Adjusting the AM antenna
Adjust the location and position of the AM antenna
while listening to an AM station to achieve the best
reception.
(CR-545UKD)
For details see page 37
"Tuning Aid".