Listening To The Radio; Tuning Into Radio Stations - Onkyo CR-535 Instruction Manual

Listening to the Radio

Tuning into Radio Stations

/
( TUN/
TUN )
When tuned into a station, the Tuned
appears. When tuned into a stereo FM station, the FM ST
indicator appears as well.
AUTO
Band
(Actual display depends on country)
Tuning into weak stereo FM stations
If the signal from a stereo FM station is weak, it may be
impossible to get good reception. In this case, switch to
Manual Tuning mode and listen to the station in mono.
1 Press the [BAND] button repeat-
edly to select "AM" or "FM".
Adjusting the Antennas
Adjusting and installing the FM antenna
Choose a location for the FM antenna while listening to an FM station.
1
Change the direction of the
antenna to achieve the best
reception.
40
YES/MODE
BAND
indicator
FM ST
Frequency
2
Affix the antenna with a thumbtack. (Do not
push the thumbtack through the antenna.)
Caution:
Be careful not to prick your finger!
2
Press the [YES/MODE] button
repeatedly to select "Auto" or
"Manual".
• Auto Tuning Mode
The AUTO indicator appears and ste-
reo radio reception is possible.
• Manual Tuning Mode
The AUTO indicator is not displayed
and radio reception will be in mono.
AUTO indicator
3
Use the Fast Reverse and Fast For-
ward [
into a station.
In Auto tuning mode, once a station is
found, tuning stops automatically.
Radio frequency can be changed in
0.05 MHz steps for FM and 9 kHz or 10
kHz steps for AM.
In Manual Tuning mode, the frequency
stops changing when you release the but-
ton. Press the button repeatedly to
change the frequency one step at a time.
Note:
On the CD receiver, you can also tune
into a station by pressing its PRESET
[ ]/[ ] button for a few seconds.
Adjusting the AM antenna
Adjust the location and position of the AM
antenna while listening to an AM station to
achieve the best reception.
]/[ ] buttons to tune