Visibility Settings (Daytime Only) - Aiphone GT SYSTEM Installation Manual

Quit the pre-set mode
1
Press the button to register the pre-set position.
2
Press the program switch of the GT-DA-L/GT-DA to finish
programming.
CAMERA PRESET: 5
CONNECTING...
CONNECTING...
Setting using a residential station (limited to stations with a zoom/wide function)
The picture can be set to display using a set zoom picture position for when a call is received from an entrance station.
When switching from the wide screen to the zoom screen, the zoom screen displays starting from the pre-set position.
1
Enter the pre-set mode from an entrance station.
2
Start communication from a residential station to display the picture at the currently set pre-set zoom position.
3
Adjust the camera zoom position using the [S], [T], [W], and [X] buttons on the residential station.
4
Press the [ ZOOM/WIDE] button (for at least 2 seconds). A beep will sound and the position setting will be completed.
5
End residential station communication.
6
Exit the pre-set mode from the entrance station.
* Setting can be performed in the same manner even if the entrance station is in programming mode.
* Pressing the entrance station call button will set a link with a residence, but pre-set settings cannot be performed.
* The position set at one entrance station will be displayed at all linked residential stations.
NOTES:
1. To change the zoom screen position that has been set, perform the zoom screen settings again.
The previous settings will be overwritten.
2. The set zoom screen position will also be displayed at the sub master monitor station.
* Pre-sets cannot be set from a sub master monitor station.
5-26

Visibility settings (daytime only)

When entrance station is installed at a location where backlighting makes viewing difficult, settings can be performed for easier viewing.
1
Enter the pre-set mode from an entrance station.
2
Start communication from a residential station to display the picture at the currently set pre-set zoom position.
3
Press the [ ADJUST] button to adjust the daytime brightness.
4
Press the [ ADJUST] button (for at least 2 seconds). A beep will sound and the setting will be completed.
5
End residential station communication.
6
Exit the program mode from the entrance station.
Quit the pre-set mode
1
Press the
2
Press the
GT-DA-L/GT-DA
- 52 -
button to register the pre-set position.
button to return to the menu.
GT-DMV/GT-DM
CAMERA PRESET
CONNECTING...
5
ZOOM BY NO. 1-9
:ENTER
PROGRAMMING
CONNECTING...
:QUIT :PRESET