Locking & Unlocking The Doors; Remote Starting - Excalibur RS-22 Operating & Installation Instructions Manual

operate the vehicle's on-board doorlocking relays. If the vehicle's Negative pulse
doorlocking system requires more than 500mA Negative output, optional relays must
be used.
Control
Module
2-Wire Connector
Green Wire To Switch Blue Wire To Switch
Door Lock Wire Door Unlock Wire
Door Lock
Ground
Switch
3 Wire Positive Pulse Systems
This doorlock system is similar to the 3 wire negative pulse system except the doorlock
switches send +12 Volt pulses to operate the doorlock relays/control unit.
Examine the wires on the back of the doorlock switch:
1) One wire will show +12 Volts, regardless of the switch's position.
2) One wire will show +12 Volts only when the switch is pushed to "lock".
Negative Pulse System Using
Direct Connection
+
Vehicle's Doorlock
Actuators
Relay Control Unit
Unlock
Lock
To Lock the Vehicle's Doors: Press & Release the upper left
• The parking lights flash once to confirm locking, and optionally, the horn will chirp once. *
The Status Light on the Receiver Unit will have one long flash when a lock signal is
received.
To Unlock the Vehicle's Doors: Press & Release the upper right
Doorlock
• The parking lights flash twice then stay on for 30 seconds to confirm unlocking, and
optionally the horn will chirp twice.* The Status Light on the Receiver Unit will have two
long flashes when an unlock signal is received.
To Activate Remote Start: Press & Release the lower left
• The parking lights will turn on and the Status Light will flash to confirm the starting
process (and, optionally, the horn will also chirp 3 times*).
• The unit will turn on the ignition circuit.
*The unit is equipped with a horn/siren output; its connection is optional and may require extra parts.
Locking & Unlocking the Doors
transmitter LOCK button
transmitter UNLOCK button

Remote Starting

transmitter START button
continued next page . . .