Excalibur RS-22 Operating & Installation Instructions Manual page 15

Jumper
Accessory Starter
Ignition #2
Wiring - 3 Wire Connector / Satellite Relay Port
The Red satellite relay port can be used, if needed, to configure optional relays to energize
additional Ignition or Starter circuits, and Omega OEM security bypass interfaces also plug
into this port. Prewired dual relay sockets are available, and a plain 3-wire harness is
provided to use this port.
22 Gauge Green Wire:
Connection If Needed.
This 22 gauge Green wire is a 500mA Negative output having
basically the same operation as the 12 gauge Green Starter output wire. If two or more
Starter wires are present in the vehicle an optional relay is needed, connected to satellite
port Green wire as shown in the diagram.
22 Gauge Red Wire:
Connection If Needed.
The Red wire supplies constant 12 Volts that can be used to
power the relay's coil only- DO NOT use this Red wire for the optional relay(s) power
input (pin 87).
Programming the Yellow/Green Wire's op-
eration: Locate and open the small access panel
on the top of the control module case. Place the
Jumper as shown on the pins below the removable
panel on the control module. The factory setting is
the center "Ignition #2" position.
500mA ( - ) Starter Output
( + ) Output For Optional Relay Coil
Anti-Carjacking can be made even more difficult to defeat with the use of "Coded Over-
ride" (Feature # 1). Instead of 1 Valet Switch press to turn it off after fully engaging,
multiple presses must be made. The number of presses, 1 through 9, are chosen and
programmed by the user Even if a customized Coded Override is used, only one Valet
Switch press is needed to cancel Anti-Carjacking before it fully engages at 60 seconds; after
that point that the correct custom Coded Override must be entered to turn off Anti-Carjacking.
How to program Coded Override:
• Feature # 1 allows the user to custom-program the "Coded Override". Place the MARS
into Features Programming Mode (page 12) and access Feature
Light flashes once and the horn chirps once to confirm that Feature
gramming, press the transmitter "LOCK" button for each digit of the desired customized
Coded Override, but wait after each single "LOCK" button press for a single Status Light
flash and horn chirp before pressing the button again for the next digit. When all of the
digits have been entered in this fashion, wait for the Status Light and horn to flash and
chirp the complete total number.
Example: for a Coded Override of "3 presses", programming would be: enter Features
Programming Mode, select "feature 1" ( response is 1 flash / 1 chirp ). Press "LOCK", wait
for 1 flash / 1 chirp ; press "LOCK" again, wait for 1 flash / 1 chirp ; press "LOCK" again, wait
for 1 flash / 1 chirp . Now continue to wait, until the MARS has 3 flashes / 3 chirps . Exit
programming mode, and the Coded Override is now 3 presses of the Valet switch.
• Feature # 8 is not used on the unit.
• Feature # 9, "Unlock Doors With Trunk Release" has the doors unlock automatically when
ever the remote trunk release is used. If this feature is turned off (press "UNLOCK" in
programming, page 11), the trunk release will still operate when used, but the doors will
#
1. After the Status
# 1 is ready for pro-