Table of Contents
Advertisement
Installation Instructions
After reading this manual, start the installation by affixing the WARNING
DECAL to a visible area in the engine compartment!
Do not attempt to install this Remote Car Starter into a manual transmission
vehicle! Doing so could cause serious property damage, personal injury,
and will void all warranties!
Be aware of, and avoid, any airbag circuitry! Due to the fact that an installer
will not be in a normal, upright seated position, severe injury may occur in an
accidental airbag deployment!
The use of a Digital Multimeter (DMM) or Volt-Ohm Meter (VOM) instead of a
standard testlight is required. This can greatly reduce the risk of an acciden-
tal airbag deployment or on-board computer damage.
Battery gases are explosive! Avoid sparks and do not smoke while working
near the vehicle's battery!
Always protect wires routed through the firewall from sharp metal edges and
hot parts of the engine! Always fuse positive wires at their source!
Installation Considerations: This entire booklet should be read before starting the
installation. An understanding of which control module wires are to be used and their
functions is essential. Installations will vary from car to car, as some control module wires
are required, while others are optional. Before starting the installation, it should be deter-
Lights and a series of horn chirps.
Any time that transmitters are programmed to operate the unitt, for
48 hours afterward every time that the ignition key is turned "on"
the horn will briefly chirp and the Status Light will flash the number
of operating transmitters. This is "Unauthorized Transmitter Alert",
protecting against unauthorized transmitters.
Hide quick links:
Advertisement
Table of Contents
