Table of Contents
Advertisement
4. For Windows Vista
a. Select "Locate and install driver software (recommended)" when the "Found
New Hardware" window is displayed.
b. Click on the [Continue] button when the "User Account Control" dialog pops up.
c. Insert the Setup/Application CD-ROM, included with your scanner, into your
CD-ROM drive when the system prompts you "Insert the disc that came with
your USB Scanner", and click on the [Next] button.
d. During the process of the installation, a message "Windows can't verify the
publisher of this driver software" might be prompted. Please ignore it, and click
on [Install this driver software anyway] to continue the installation without any
misgiving at your scanner functioning.
5. When the system completes the installation, click on the "Finish" button.
6. Follow the on-screen instructions to install all software that your new USB scanner
requires.
7. After the software is installed, close all open applications and click on the "Finish"
button to restart your computer.
8. After the computer is restarted, you will be prompted to perform the scanner
calibration.
9. Insert the special calibration sheet, included with the scanner, face down into the
page feed of the scanner.
10. Follow the on-screen instructions to complete the scanner calibration.
If the scanner installation is not started and displayed automatically on
the screen, click "START", select "Run" and type in "D:\Install" (where
D: is the drive letter assigned to the CD-ROM drive of your computer.)
Attention
S
t
e
p
3
.
T
e
s
t
i
n
g
S
t
e
p
3
.
T
e
s
t
i
n
g
The following test procedure checks to see if the scanner is properly functioning
with your computer and the scanning software. Before testing your scanner, double
check to make sure that all connections are securely fastened.
To properly test your scanner, please perform the following steps:
t
h
e
S
c
a
n
n
e
r
t
h
e
S
c
a
n
n
e
r
9
Advertisement
Table of Contents
Troubleshooting
