Miele CVA 5060 Installation And Maintenance Manual page 4

Problem solving guide
4
The water temperature could be too high. The machine will
remain switched off until the water has cooled down
sufficiently.
There could be stones in amongst the coffee beans. If this is
the case, the machine will switch itself off automatically within
20 seconds to avoid damage.
- Call the Miele Service Department.
^ Check that the plug is correctly fitted in the socket.
. . . the lighting suddenly switches itself off.
If the machine has not been used for 15 minutes the lighting
will switch itself off automatically.
. . . you cannot read the display.
If the machine is installed too low down, the display can be
hard to see.
^ Try and improve this by adjusting the display contrast or
brightness.
. . . milk froth or milk is not flowing out of the central
spout.
The spout is clogged up.
^ Clean the milk pipework as described in "Cleaning and
Care".
. . . a message appears in the display reminding you to fill
or replace the milk flask even though it is full and
positioned correctly.
^ Clean the flask thoroughly, paying particular attention to the
area around the handle and the neck.
Any soiling in these areas can prevent the sensors for the
milk flask from working properly.
. . . the coffee grinder makes a louder noise than usual.
There may be stones in amongst the coffee beans, or the
bean container may have emptied during grinding.
^ Switch the machine off immediately.