Miele CVA 5060 Installation And Maintenance Manual page 36

Installation
Installation
36
Before installation make sure that there is no power supply
to the machine. This also applies should it ever need to be
taken out of its housing unit.
The machine must be built in before it is operated.
You will need two Allen keys (size 3 and 5) for installing
the machine.
^ Using the large allen key, unscrew all four feet out by about
2 mm.
^ Push the machine all the way into the niche until there is a
resistance. Then check the height to make sure it is sitting
centrally in the unit and that it is level.
If this is not the case, realign the 4 feet underneath the
machine using the large allen key.
The feet can be unscrewed by up to approx. 10 mm.
^ If the furniture unit walls are 19 mm thick you will need to
drill four holes in the sides for securing the machine. To
mark the position of these holes:
– Align the machine in the niche. Screw the side socket
screws inside the machine in a little so that they make
indents in the side walls and then unscrew them again.