Problem Solving Guide - Miele CS 1212 Operating And Installation Manual

Problem solving guide

,
Installation work and repairs to
electrical appliances must only be
carried out by a suitably qualified
and competent person in strict
accordance with current local and
national safety regulations (BS 7671
in the UK). Repairs and other work
by unqualified persons could be
dangerous. The manufacturer
cannot be held liable for
unauthorised work.
What to do if ...
... the cooking zones do not heat up.
Check whether the mains fuse has
tripped. If it has, reset the trip switch.
If there is still a problem, turn the
control to "0", and disconnect the
appliance from the electricity supply for
approx. 1 minute.
If the hob still will not switch on, contact
a qualified electrician or the Miele Ser-
vice Department.
... ß is flashing in a cooking zone
display.
Check whether
– the zone was switched on by mistake
without a pan on it.
– the pan being used is suitable for
use on an induction zone, and that it
is large enough (see "Pans").
32
... C flashes alternately with a power
level in a cooking zone display.
The power level on this cooking zone
has been reduced because the booster
has been activated on the cooking
zone which is paired with it.
... C flashes alternately with 0 in a
cooking zone display.
The cooking zone has switched off
because
– Twin booster level ll has been
activated on the cooking zone which
is paired with it.
– There is no pan on the cooking zone,
or the pan is unsuitable.
– the overheating protection
mechanism has been triggered (see
section "Protection from
overheating").
... after a cooking zone has been
switched on for few seconds the "d"
symbol appears in the display and
the cooking zone does not heat up.
The hob is in demonstration mode.
To deactivate demonstration mode turn
the right control twice briefly for less
than one second anticlockwise as far
as it will go and then turn it again and
hold for approx. 3 seconds.