General
To avoid the risk of damaging the
hob fit the wall units and extractor
hood before installing it.
~
The veneer or laminate coatings of
worktops (or adjacent kitchen units)
must be treated with 100 °C
heat-resistant adhesive which will not
dissolve or distort.
Any backmoulds must be of
heat-resistant material.
~
This appliance must not be used in
a non-stationary location (e.g. on a
ship).
~
The hob may only be installed
above a Miele oven if the worktop is at
least 40 mm thick.
Safety instructions for installation
~
Observe carefully the safety
distances given on the following pages.
~
After installation, ensure that the
connection cable is without hindrance
and that there is no mechanical
obstruction which could damage it,
such as a drawer.
~
This appliance must not be installed
over a dishwasher, washing machine,
tumble dryer, refrigerator or freezer.
The high temperatures radiated by the
hob could damage the appliance
below.
All dimensions in this instruction booklet
are given in mm.
33