Problem Solving Guide; Check And Fault Messages - Miele T 4804 C Allerdry Operating Instructions Manual

With the help of the following notes, minor faults in the performance of the
appliance, some of which may result from incorrect operation, can be put right
without contacting the Service Department.
Repair work to electrical appliances should only be carried out by a suitably
qualified person in strict accordance with current local and national safety
regulations. Repairs and other work by unqualified persons could be
dangerous. The manufacturer cannot be held liable for unauthorised work.

Check and fault messages

Problem
The programme stops
and 0 and Finish
appear in the display.
The buzzer sounds.
0-§ appears in the
display.
The Low temperature
indicator lamp flashes.
The programme stops
and Hygiene or Finish
flashes in the display.
The buzzer sounds.
Possible cause
This is not a fault.
The electronic unit has
recognised that there is no
laundry in the drum and
cancelled the programme.
Drying individual garments
or items which are already
dry can also cause the
programme to be cancelled.
The electronic system lock
is activated.
No obvious cause.

Problem solving guide

Remedy
– Use the Warm air
programme (timed
drying) to dry
individual items.
To delete the fault
message:
– Open and close the
door.
You will need to
deactivate the system
lock before the dryer can
be used (see "Electronic
system lock").
– Switch the dryer off
and then on again.
– Then start the
programme again.
If the programme stops
and a fault message
appears again there is a
fault. Contact the Miele
Service Department.
33