Installation Site; Transporting The Dryer To Its Installation Site; Building Under A Continuous Worktop / In A Row Of Kitchen Units - Miele T 4804 C Allerdry Operating Instructions Manual

For condenser tumble dryer
Table of Contents

Advertisement

Installation site

,
Make sure the dryer door can be
opened without hindrance after
installation.
Transporting the dryer to its
installation site
When moving the dryer you can hold it
by the lid where it protrudes to the rear
of the dryer. To manoeuvre the dryer
out of its packing case to its installation
site you will also need to hold it by the
front feet. Do not hold the dryer by the
door.
Building under a continuous worktop /
in a row of kitchen units
,
It is very important to avoid a
build up of heat.
The warm air which is expelled from
the rear of the dryer must be able to
dissipate. Otherwise drying times
will be increased unnecessarily.
You can ensure that the warm air can
dissipate by:
– Adjusting the screw feet so that there
is a gap of at least 20 mm between
the floor and the bottom of the dryer.
– Creating a gap for the dryer in the
kitchen furniture plinth facing.
– Creating ventilation gaps in the
kitchen unit.
Installation and connection
,
The dryer should not be installed
next to a refrigerator or freezer. The
warm air expelled from the rear of the
dryer would increase the temperature
around the refrigerator's/freezer's heat
exchanger causing the compressor to
run continuously.
If it is not possible to install the dryer
anywhere else, then the
refrigerator/freezer must be sealed off
from the dryer.
,
A building under kit* with a
coverplate to replace the appliance
lid is required. It must be fitted by a
suitably qualified person to ensure
electrical safety.
N.B. If you wish to push your dryer
under a worktop and there is space to
do this without removing the lid, a
building under kit is not necessary.
Otherwise the building under kit is
essential.
The building-under kit is supplied with
its own installation instructions.
– N.B. When built under drying times
may be longer.
– The electrical socket must be
located in an accessible position
near the machine.
With niche heights of:
– 830-840 mm, longer screw feet* are
required.
– 870/885 - 915/930 mm, one or two
raising kits* are required.
* Accessory available to order
43

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents