Winding The Bobbin; Removing The Bobbin - Janome 6019QC Instruction Book

1
2
1
(A)
2
(B)
3
1
2
3
5
4
2
1
8

Winding the Bobbin

•

Removing the bobbin

Slide the hook cover release button to the right, and
remove the hook cover.
Lift the bobbin out.
1 Hook cover release button
Hook cover
2
Setting the spool of thread
Lift up the spool pin. Place the spool of thread on the
spool pin with the thread coming off the spool as
shown.
(A) For an ordinary spool: Use the large spool holder.
1 Large spool holder
(B) For a narrow or small spool: Use the small spool
holder.
Small spool holder
2
•
Winding the bobbin
1 Guide the thread around the thread guides (A), (B)
and bobbin winder thread guide.
4 2 Insert the thread through the hole on the bobbin,
threading from the inside to the outside. Put the
bobbin on the bobbin winder spindle.
1 Thread guide (A)
2 Thread guide (B)
Bobbin winder thread guide
3
4 Bobbin winder spindle
3 Push the bobbin winder spindle to the right. With
the free end of the thread held in your hand,
7
depress the foot control. Stop the machine when
6
the bobbin has made a few turns, and cut the
thread close to the hole on the bobbin.
9
5
Bobbin winder stopper
8
Depress the foot control again. When the bobbin is
4
fully wound, it will stop automazly. Return the
bobbin to its original position by moving the spindle
to the left, and cut the thread as shown.
NOTE: Do not move the bobbin winder spindle while
the machine is running.
Additional spool pin
Insert the additional spool pin into the spool stand and
the hole on the machine. Place the felt and spool on
the spool pin as shown.
6
Additional spool pin
7
Felt
8
Hole for additional spool pin
9 Thread guide
9